How do I unlock unify channel/power on QQ190?
Am in Australia (HAM not required) and need to unlock my QQ190 Unify to access Band E, Channel 3, Freq: 5665 (accessing Band E would be good enough). Also need to increase power output up from 25mw. I have always been using this channel, but can’t access it or increase the power without unlocking. Can anyone help??
Cheers
The inputs will not be registered by the OSD if your radio has not been properly calibrated. Make sure that your trims are centered and that your radio outputs 1000 uS at minimum values and 2000 uS at maximum values with 1500 uS at the midpoint.
If you are using a Spectrum radio you will have to increase the endpoints to 150% to achieve these values. After you have got the radio setup properly, you should perform the RC calibration again by pushing down the side button on the electronics stack and holding it for 15 seconds.
Once it is all setup properly, you should be able to save osd settings by holding your left stick s to the right.
Haha. I just saw your other reply. I’m glad that you got it working.