OSDoge and Naze32 Full with Futaba 14SG
I wonder if i could get a technical support regarding OSDoge RSSI on Futaba 14sg (R2008SB)
Recently, I ordered OSDoge and Naze32 Full Rev6, but i do not know how to recieve RSSI data from OSDoge.
I am using R2008SB ( S.Bus), and still trying to figure out if there’s anything i need to hook up on the osdoge. (RSSI signal jumper)
It depends on the RSSI output of your Futaba receiver. If it outputs an analog signal, then you can hook that directly up to the osdoge RSSI input. If it outputs a digital signal, then you will have to place a solder jumper across the pads labeled RSSI filter on the bottom of the OSDoge. This essentially converts a digital signal to analogue which is what the OSDoge needs in order to display RSSI on the screen.
After that, you will have to calibrate the RSSI via the OSD menu. This video explains how: