Hello – I have bought a few of these sweet quads from you guys and had been running a great firmware for the last year no issue.
My TX went bad (DX18 Stealth Spektrum) and sent it in to Horizon for repair and they replaced a transmitter board.
OK I get the TX back and rebind back to my QQ190… the try and check switches on Betaflight. Use my goggles to run thru SET UP and the Colibri Race will not see my RX. I try BF and cannot get the receiver to be seen by the Colibri.
I try everything I can find online to use TBS Agent to put on the latest Betaflight QQ firmware and the Agent gets stuck in WAITING FOR COLIBRI RACE… spins and nothing happens.
This never happened before, any previous updates were flawless. ANY HINTS TO TRY HERE? I have pressed bootloader, not press BL when plugging in USB… anyway not results differed. Tried diff cords and no change.
Ok so this eve I plugged into BF and went for a manual BF update to Colibri Race just to be sure… worked smooth as butter. BF now sees my RX and I set up an any normal build I have. I dont want to lose the TBS fiunctionality so I really want to use TBS Agent and get the QQ dedicated update put in the board.
I figured I would give a shout to see what you guys might have me try before I abandoned the QQ update and just move on with my own BF update.
In the worst case, could you send me a PID screen shot… I can at least use the latest PIDS you guys have on this and I move from there.
Thanks if you can offer any advice.
1. Try a new USB cable.
2. Make sure TBS agent beta releases is checked.
3. It’s possible that you have manually overridden the port settings In betaflight so if you can get communication with the board via Betaflight, try changing the receiver settings manually.
4. Make sure that you are plugged into the top USB port on the powercube in the QQ190
4. If you updated the colibri to a recent firmware, try rolling back to 3.0.1
I hope that helps you!