QQ190 with TBS Bulletproof 25A

3.23K viewsqq190
0

I’ve just noticed arm width on the QQ190 is 14.5mm. I’ve ordered TBS Bulletproof 25A, which are 17mm. So I’m looking at and overhang of 1.25mm on each side. Do you think this will be a problem?

0
Anonymous 0 Comments

Those motors are pretty nice, but they draw a high current. Check the thrust data and your prop choice to make sure that you are sizing your esc accordingly. More info on how to do that here:

 

https://quadquestions.com/blog/2017/02/22/choose-right-size-motors-drone/

Anonymous edited answer March 9, 2017
0
Anonymous 1 Comment

Thank you Anthony.

I’m planning to use EMAX RS2205-S 2600KV MOTOR RACE SPEC, what do you reckon?

Anonymous edited comment on answer March 9, 2017

Those motors are pretty nice, but they draw a high current. Check the thrust data and your prop choice to make sure that you are sizing your esc accordingly. More info on how to do that here: How to size motors & Escs

0
Anonymous 0 Comments

Besides a minor annoyance, I don’t think it will be an issue.  We had several QQ190s run them without issue, and I can even tell you that this frame was one of the originals used for the testing of the ESCs when they were in development.  Our favorite setup was the power cube elite, bulletproof escs, and ZMX Fusion 2204 2300kv motors.

We designed the 190 to fit common ESC widths, and the bulletproof escs are a little wider than most.

Question stats

  • Active
  • Views3230 times
  • Answers3 answers