I'm not sure what radio you're using but you'll want to set up AUX channels on your radio and apply them to desired switches. In this case 2 AUX channels/switches. Then in the "Modes" tab of cleanflight...
The mid throttle oscillations most likely mean that your frame is generating noise. The D term increase would help a bit, but it won't completely fix the problem and it may cause your motors to get hot...
Hey Mark, I fly my QQ with airmode always enabled and here is my input. Landing in airmode can be tricky. I wouldn't try to tune the quad for landing it because it won't completely solve the problem,...
Are you sure you have the right firmware on it/the correct drivers on your mac? Here is a link on how to reflash the fc. http://kiss.flyduino.net/dwkb/flash-fc-mac/
I agree. The biggest thing I've noticed about higher end goggles is not only the image quality, but also that the image feels a lot larger. Lower end goggles make it seem like the image is at the end of...
I don't know if you can see into the frame, but I use double sided tape to stick my Unify PRO to my Frsky XSR with the pinouts towards the front of the quad. If you do this make sure you bind the receiver...
In order to lower the idle speed you'll want to go into the configuration page on cleanflight. On the right side at the top of the page there is a tab for "minimum throttle". This shouldn't be over 1150,...
I'm going to assume that you have the proper drivers installed since you got the first board to work. My only other input would be to make sure that you have "auto-connect" off, and have the manual baud...