Naze32 rev6 breakout cable to AR400 connections?
I purchased a Naze32 Rev6 board and have some confusion as to which pins I should be using to connect to my AR400? Most of the information online for the rev5 boards depicts using the female to female breakout cables from the double stacked 10pin connection that are 5 on top and bottom, but on the rev6 board, those appear to be the connections for the telemetry/voltage alarm/buzzer etc. I have a breakout cable that goes to the straight line 10 pins on what appears to be the R/C inputs, but am not sure which leads I should be plugging in from there to the AR400 for RUDD, ELEV, ALE, THRO, BND/DAT to which correlating pins (1-8)? Any help you could provide would be much appreciated for this NewB. Thanks
Finally have this setup running after several trial and error attempts with cleanflight to verify. From the straight 10 pin connection on the Naze32 rev6 board : (1) GND, (2) 5V+, (3) Sig-1 Throttle, (4) Sig-2 Aileron, (5) Sig-3 Elevator, (6) Sig-4 Rudder. On my spektrum DX6i controller, I had to switch the YAW and ROLL to reversed in the setup on the controller itself as they were working backwards when I verified them in cleanflight. Hope this helps anyone else in the situation. Thanks again for your help.