Unable to Arm the QQ190 after a small crash
Hello, I had my QQ190 out today and a very minor crash and dumped it in the long grass. since then I have been unable to arm the quad via the usual switch.
The whole quad checks out ok on the start-up self check splash screen. In beta flight I’m able to spin up all the motors and see all the stick and switch movement from the TX. Everything looks good in software and hardware even after a recalibration and firmware re-flash I just cant arm. Any tips as I am completely stuck for ideas at the moment.
Thanks
Andy
Most likely you have a dead accelerometer. You can check the sensors tab .they should all move when the quad moves. Your account hardware is set to auto “set acc_hardware = AUTO” so it sounds like it’s not detecting the accelerometer. You can replace the colibri with minimal effort. We have them in stock in Denver .
You will also want to pickup the special install tool available here: